Pbb-da-2ya指针式压力变送器宝鸡华水HSA压力传感器

更新时间:2020-01-15 02:54
点击图片查看原图
 
单价: 390.00元/¥
起订: 1 ¥
供货总量: 822 ¥
发货期限: 自买家付款之日起 1 天内发货
所在地: 陕西 宝鸡市
有效期至: 长期有效
最后更新: 2020-01-15 02:54
联系人 李红梅  
浏览次数: 1000
询价

详情介绍

联系方式

详细说明
品牌 :
HSA
型号 :
PB-DA-2YA
加工定制 :
类型 :
应变式压力变送器
测量范围 :
-0.1-0.4-6MPa
测量介质 :
水油气
精度等级 :
1.0
输出信号 :
4-20mA/0-10mA/0-5V
防护等级 :
IP32/IP65
电源电压 :
18-24V
接口尺寸 :
M20X1.5
PB-DA-2YA :
变频器专用

PB-DA-2Y(A.B.C.D)系列压力变送器

PB-DA-2Y(A.B.C.D) Series Pressure Transmitters

  1. 用途

    I Functions

    PB-DA-2Y系列产品利用专利技术与德国Analog Microectcsco.,Ltd公司合作开发的新型压力变送器,采用精密光刻箔式电阻应变计及德国AMG公司生产的专用变送器用集成电路。它设计新颖独特,工艺先进,信号输出稳定,优良的性能价格比,是远传压力表的理想替代产品。它可广泛应用于冶金、电力、自来水、化工和石油等工业现场,实现远程监控和控制。

    With the patented technology and developed in cooperation with German Analog Microectcsco., Ltd, PB-DA-2Y Series products as new pressure transmitters adopt precisionlithography foilresistance strain gauge,anddedicatedtransmitter-use integrated circuitsfrom AMG. They are featured with unique design, advanced manufacturing technology, stable output signals and cost-effective figures. It is a kind of ideal alternative for transmissible pressure gaugeand can be widely used in metallurgy, electronics, tap-water, chemicaland oil industries, which can realize remote monitoring and network control.

  2. 技术参数

    II Technical Parameters

  3. 信号输出精度:1.0 级

    The accuracy of signal outputs: 1.0 degree

  4. 表面指示精度:1.6 级

    2. The accuracy of surface indicator: 16 degree

    3.量程:-0.1—0.3Mpa 0~0.4Mpa00.6Mpa01.0Mpa

    01.6Mpa02.5Mpa 04.0Mpa 06.0Mpa

    3. Measuring Range:

    4.信号输出:4-20mA / 0-20mA / 0-10mA / 0-5V/1-5V

    4. Signal Outputs:

    5.工作电压:24V DC 负载电阻:1.2KΩ(标准24V/DC电源)

    5. Operating Voltage:24V DC LoadResistance: 1.2KΩ(Standard 24V/DC Power Outlet)

    6.传输方式:二线制数字化智能三线制

    6. Transmission Mode: two-wire digital intelligence three-wire system

    7.接头螺纹:ZG1/2 M20x1.5

    7. Connection Thread

    8.使用温度:-20~45℃

    8. Operating Temperature

    9.防护等级:IP30

    9. Protection Grade

    三、使用须知

    III Notice of Use

  5. 仪表适用于测量各类液体、气体及其它流体压力。上限不应超过3/4,测量波动压力时上限不应超过2/3, 压力在两种情况下都不低于上限的1/3。

  6. The instrument can be applicable to measure various types of liquid, gaseous, or other fluid pressure. Upper limit should not be exceeded to 3/4, when it applies to measure surge pressure, upper limit should not be exceeded to 2/3, and minimal pressure should be not less than 1/3 of the upper limit in both of two situations.

    2.露天安装时,都应加遮雨装置

    2. Rainproof set is necessary in open-air installation

    3.仪表出厂时已加装了阻尼螺钉. 不要拆除。但被测介质急剧冲击震动时应加装相的YFN-01阻尼抗震器(选件)

    3.All instruments arefactory equipped witha damping screw,please do not remove it. When measured mediumvibrates fiercely, YFN-01 suppressing vibrationdamper should be added to install. (Option Item)

    4.为了仪表的安全,仪表供电应加装SAB-99电力线路避雷器及电涌抑制器(选件)。

    4. For the instrument safety, the power supply should install SAB-99

    Power line lightning arresterand surge suppressor. (Option Item)

    5.仪表应装在和测量点同一水平线上,环境温度为0℃+45℃,相对湿度不大于80%场合使用。当环境温度为-20℃+85℃时仪表也可工作,但测量精度有所下降。超过85℃应配加T1专用散热器(选件)

    5.The instrument should be installed in line with the measurement point, which requires the environmental temperature is from 0℃~+45℃, and the relative humidity is not more than 80%.Under the range of -20℃~+85℃, instrument works but the accuracy decreases. T1 dedicated radiatorshould be installed when environmental temperature is above 85℃. (Option item)

    6.仪表用直流电源DC:20V24V、交流纹波<5mV单台仪表按1.2W/24V50mA计算

    6. DC power for instrument use: DC:20V~24VAC Ripple<5mVfor each instrument 1.2W/24V~50mA

    7.仪表供电必须正确,直流供电不能反接。

    7. The power supply should be connected correctly, DC cannot be reversed connected.

    8.不要自行拆卸仪表,人为造成的仪表损坏、雷击及电涌和过电压造成的仪表损坏、急剧的机械震动和水锤冲击造成的仪表损坏不属保修范围。

    8. Do not repair or disassemble the instrumentby yourself, damages caused by human error, lightening, electrophoresisand overvoltage, sharp mechanical vibrationand water hammer , do not belong to the warranty scope.

    四、接线方法

    IV Connection Method

  7. 三线制电缆输出色标:

    Three-wire output color code:

    红色:+电源(+V ) 黑色:公共地线 (GND) 黄色:输出信号+(OUT)

    Red: + power Black: Ground Wire Yellow: Output Signal

    三线制德国激励防水接头信号输出:

    Signal Outputs of the three-wire German Inspire waterproof connectors

    接头1:+电源(+V 接头2:输出信号+(OUT) 接头3:公共地线 (GND)

    Connector 1: + power Connector2: Output Signal Connector 3: Ground Wire

    2.二线制4-20毫安电缆线 红色为+电源色为信号+

    Two-wire 4-20Ah Cable Red:+ Power Yellow: Signal

    二线制4-20毫安航空插座 信号输出1+电源 2信号+

    Two-wire 4-20Ah Aerial Socket Signal Outputs 1:+Power 2: Signal

    二线制4-20毫安德国激励防水接头 信号输出1+电源 2信号+

    Two-wire German Inspire waterproof connectors Signal Outputs 1:+Power 2: Signal

    五、电源与负载特性 (图1)

    V Power Supply and Load Characteristic

    工作区(Working Area)

    六.订货须知

    VI Ordering Information

    1.PB-DA-2Y(A)变频器专用配套 外壳材质304 部件96黄铜

    Special affiliatedto frequency converterShell Material 304 unit 96 copper

  8. PB-DA-2Y(B)用于测量有腐蚀介质压力 外壳材质304 部件316L不锈钢

    Apply to measure the pressure of the mordant medium Shell Material 304 unit 96Stainlesssteel

    3.PB-DA-2Y(C)用于测量真空及负压 外壳材质304 部件316L不锈钢

    Apply to measure vacuumpressure and negative pressure Shell Material 304 unit 96 Stainless steel

    4.PB-DA-2Y(D)有辅助电接点输出 外壳材质30碳钢 部件96黄铜

    For output with the extra electriccontactShell Material 30carbon steelunit 96 copper

    5.通常供货为径向,轴向须订货时特别说明

    Radial Directionwill be ordered generally, unless axial directionis specifiedin order placing.

更多>本企业其它产品
宝鸡华水自动化工程有限责任公司为你提供的“Pbb-da-2ya指针式压力变送器宝鸡华水HSA压力传感器”详细介绍,包括Pbb-da-2ya指针式压力变送器宝鸡华水HSA压力传感器价格、型号、图片、厂家等信息。如有需要,请拨打电话:09173802128。不是你想要的产品?点击发布采购需求,让供应商主动联系你。

宝鸡华水自动化工程有限责任公司

  • 无线压力温度液位,压力变送器,液位变送器,软硬件设计

网站首页  |  关于我们  |  联系方式  |  使用协议  |  版权隐私  |  网站地图  |  排名推广  |  广告服务  |  积分换礼  |  网站留言  |  RSS订阅  |  违规举报